Heat pump or furnace? That is the first thing that matters when the heat quits in Coeur d'Alene, ID, because the two fail in completely different ways. Heat pumps tend to ice over when defrost stops working, get stuck in cooling when a reversing valve fails, or quietly lean on the electric backup strips, at several times the normal operating cost, when the outdoor unit dies. Gas furnaces typically come down to the flame sensor: once oxide coats it, the burners light but the flame cannot be proven, so the board cuts the gas and locks out after three tries. After that, we most often find cracked hot surface igniters, stuck pressure switches, clogged condensate traps on high-efficiency models, and blower motors at the end of their life.
Our most requested repair is Furnace Repair. If something has stopped working, start there.
Warning Signs for Heating Repair
The sooner you notice these red flags, the easier and cheaper the fix. Watch for these telltale signs:
- A rotten-egg, burning, or musty smell once the heat kicks on
- Some rooms warm while others stay stubbornly cold
- Thick ice or frost covering the heat pump outside
- Cold air, or no air at all, when the thermostat calls for heat
- Banging at startup caused by burners lighting late
- Frequent on-off cycles that never bring rooms up to temperature
- A furnace that tries to light, clicks, and then quits
- Energy costs climbing even though the house feels colder
Act Before It Gets Worse
A failing capacitor, clogged condensate drain, or dirty flame sensor rarely fixes itself and usually gets more expensive to address the longer it runs. If you notice any of these signs, call (208) 208-1842 for a prompt inspection.
